Tensioning rails for electric motors

Motors with V-belt pulleys are frequently used. Since these often require retensioning, tensioning slides and rails are employed. Here in our shop, you will find a small selection from our product range. Our company specializes in three-phase motors, frequency converters, and geared motors. Our drives are available as energy-saving motors in IE1/IE2/IE3/IE4 and IE5. Electric motors with specific requirements are often needed. We are the ideal partner for you in these cases, because our expert staff, combined with an extensive motor inventory and our own final assembly, allows us to offer you a wide variety of motor options.

Chip slide + clamping rail for forward, reverse,
Left/right alignment

Electronic brake devices

Electronic brakes are used to decelerate squirrel-cage asynchronous motors and single-phase AC capacitor motors within 10 seconds after being switched off. Brake switches for external mounting are available for 1.1 kW, 1.5 kW, 2.2 kW, 3 kW, 4 kW, 5.5 kW, and 7.5 kW motors.

PTC thermistor protection

The drives offered here are mostly prepared for temperature monitoring with PTC thermistors. To use this monitoring, you will need the corresponding PTC release device.

The design and the terminal box

The motor design is variable upon request. Even with heavy-duty AC motors, from 4 kW to 500 kW, the motor feet can be reconfigured. This allows a B3 foot-mounted motor to be converted into a B5 flange-mounted motor, or a B3/B5 foot/flange motor combination. A further advantage is the ability to configure the drive for terminal box mounting in various configurations: top, left, right, and even bottom.

Special engine versions

Here you can see a selection of various electric motor designs. These include, for example, electric motors/geared motors with:
– Frequency converter setups
– External fans
– different voltages
– different frequencies
– Protection classes IP54, IP55, IP65, IP66
– UL/CSA certified
– Naval versions
– Insulation class H
– Protective roof on the fan hood
– electrically insulated ball bearings
– cable brought out
– Special paint finishes
– PTC temperature sensors
– Bimetals
– Cold conductors
– Temperature sensors such as PT 100
– Storage temperature monitoring
– Standstill heaters
– Terminal box left/right/top
– Special flange
– Special waves
– second wave end
– Aluminum-stainless steel fan blades
– Stainless steel screws (D 086 DMA)
– Rotary encoders
– Tachogenerators
– Incremental encoders
– NU bearings/fixed bearings
– pre-tensioned bearings
– Relubrication equipment
– special vibration qualities
– Mounted motor switches
– Rain protection roofs for AC motors
– Clamping slides and clamping rails