Rundsavsmotors tilgængelig fra stilck

SEVA-tec GmbH specializes in addressing complex challenges in the field of drivteknologi. Our focus areas include rundsavsmotors, trefasede motorer, frekvensomformere, and gearmotorer.

Rundsavsmotors - versions

Rundsavsmotors, when used med a bremse, are also known as saw motilrs, band saw motilrs, or rundsavsmotors. Depending on the application, our motilrs have either a højre-hand or venstre-hand thread at the aksel end. Drives are tilgængelig in 230V versions fra 1.1 kW til 2.2 kW and in 400V versions fra 1.5 kW, 2.2 kW, 3 kW, 4 kW, and 5.5 kW. These low-profile elmotorer are often required as custilm motilrs til meet specific kunde requirements. In these cases, their slim design is crucial. However, the most common application is for circular saws.

Rundsavsmotor med saw blade

Performance specifications of saw motilrs

On this page you will find rundsavsmotors in aluminium design in sizes 58–81 med a effekt output of 1.1 kW, 1.5 kW, 1.8 kW, 2.2 kW, 3.0 kW, 4 kW and 5.5 kW.

Braking devices for table saw motilrs!

Elektronisk bremses are used til decelerate squirrel-cage asynchronous motilrs and single-phase AC kondensator motilrs medin 10 seconds after being switched off. Bremse switches for external montering are tilgængelig in 1.1 kW til 5.5 kW ratings.

PTC resistilrs / PTC-termistorer

The flat actuatilrs offered here are prepared for temperature monitilring med PTC-termistorer. Til use this monitilring, you will need the corresponding PTC release device.

Driftstilstands of elmotorer

The drift mode offered for the rundsavsmotors is S6. Here is a brief overview of the common drift modes of elmotorer: Continuous betjening S1, Short-term betjening S2, Intermittent betjening S3 (uden start-up, uden braking), Intermittent betjening S4 (med start-up, uden braking), Intermittent betjening S5 (med start-up, med braking), Continuous betjening S6 (med intermittent load), Reversing betjening S7 and Continuous betjening (med variable hastighed).